Drill Guide For Pipes And Corners 3D Printer Model
The file 'Drill Guide For Pipes And Corners 3D Printer Model' is (stl) file type, size is 72.4KB.
The file 'Drill Guide For Pipes And Corners 3D Printer Model' is (stl) file type, size is 72.4KB.
This drilling guide helps to drill or tap pipes, poles and corners perpendicularly with its 90 degree groove on the bottom.
Useful especially for piloting holes when drilled on smaller pipes.
Only needs to be clamped to the drilled workpiece.
For demonstration I drilled a piece of pipe and a corner of my table.
Hole sizes in mm 12, 10, 8, 6, 4, 5, 3, printer into the piece.
! Printer settings must be accurate for the drill sizes to match !
| Drill_guide_12-3_v1.stl | 275.3KB |
