Dremel table saw with cutting angle adjustment
I was needing to make cuts at 45 degrees with my microrectifier, so I found this project https://www.thingiverse.com/thing:2365532 and from it I created my modifications.
It is preferably necessary to have some equipment to check the angle with greater precision if necessary because it has a few deliberate gaps for fine adjustment. but it is surprisingly firm once mounted.
recommend too; https://www.thingiverse.com/thing:4758273
m3 screws and nuts are used.
| Cuting-plate-ticotico.stl | 130.0KB | |
| Cutting-plate-tampao.stl | 110.0KB | |
| Cutting_plate_2tampao.SLDPRT | 2.0MB | |
| Cutting_plate_2ticotico.SLDPRT | 1.8MB | |
| Dremel-externo-rafa.stl | 221.5KB | |
| Dremel-interno-rafa.stl | 74.1KB | |
| Dremel_flex_holder-do-rafa-interno.SLDPRT | 3.1MB | |
| Dremel_flex_holder_do_rafa_externo.SLDPRT | 3.7MB | |
| L-flex-holder-table-rafa.stl | 151.6KB | |
| L_flex_holder_table.SLDPRT | 3.2MB | |
| R_flex-holder-table-rafa.stl | 148.2KB | |
| R_flex_holder_table.SLDPRT | 3.8MB |
