This holds a wireless Dremel 12v max battery charger. I wanted to hang it on the wall, on some Gallowtech panels, to keep it out of the way. The charger is angled to look nice on a tabletop, so this wall mount compensates for that, putting the battery just barely above horizontal, and allowing the LED and emblems to remain visible.
Files include a Gallowtech version, as well as a simple screw version for use on any surface.
I printed this on its side. I used two m5x20 allen head screws and nuts on the split end to gently clamp it around the charger. This is good for Gallowtech hanging. But, If simply screwing to a wall or other surface, you could easily just put two general purpose screws through those holes instead.
To put it around your charger, you will need to flex the print to get the charger over the nubs inside with keep it from sliding side to side once in place.
I used PLA with 60% Infill.
| Dremel_wall_charger_mount_-_Gallowtech.STL | 212.0KB | |
| Dremel_wall_charger_mount_-_Gallowtech.x_t | 369.0KB | |
| Dremel_wall_charger_mount_-_Screws.STL | 194.7KB | |
| Dremel_wall_charger_mount_-_Screws.x_t | 305.8KB |
