I really liked the dream catcher earrings created by OnePunchMan however did not have any feathers to attach so I decided to print some. I used the feather earrings by Vivenda, but as I needed to shrink them down so small, there was not enough filament on the end to fit a jump ring through. I used Tinkercad to add a larger cylinder. I printed more feathers than I needed incase I broke one or two.
The dreamcatcher is printed in wood PLA filament and the feathers are in Bronze PLA. All printed at 0.1mm resolution and infill of 100%. I heated a sewing needle (held by pliers) using a lighter and pierced it through the end of the feathers to fit the jump ring though easier.
| dreamcatcher_feather_earrings.stl | 3.6MB |
