I designed this mounting bracket to replace the kitchen silverware drawer slide bracket that broke last night.
There are two versions. The reinforced version is thicker and may be in the way if the drawer rails don't extend past the end of the drawer. Even with the reinforcements I moved the printed part to a lighter drawer and an original part to the silverware drawer just to be safe. I also only did 10% infill so we will see how it holds up.
The original brackets are made to float back and forth a little in the track. These printed ones might not move quite as well so you may want to leave the screw slightly loose.
edit: I have added STLs for left and right backplate files. These have not been printed and are untested. Screws that can go in flush are probably needed so the bracket can float a bit. If anyone tries them let me know how it goes.
Printing:
This was done in PETG. Supports from build plate only. The overhang was slightly rough but no one will ever see it.
| Drawer_Bracket_Backplate_left.stl | 31.1KB | |
| Drawer_Bracket_Backplate_right.stl | 31.1KB | |
| Drawer_Bracket_Left.stl | 29.5KB | |
| Drawer_Bracket_Left_reinforced.stl | 25.5KB | |
| Drawer_Bracket_Right.stl | 29.5KB | |
| Drawer_Bracket_Right_reinforced.stl | 25.5KB |
