A simple system of dividers for drawers. Use L-connectors on corners, T-connectors on outside straights and cross connectors for inside nodes. Print the necessary dividers and connect them by slotting connectors on them from above. The example uses only regular size holes, but the dividers are sized in multiples, so you can mix and match.
If you need higher dividers (original height is 20 mm), simply scale both dividers and connectors by the same factor in Z-direction.
| Cross_connector.stl | 365.6KB | |
| Divider_100mm.stl | 2.2KB | |
| Divider_150mm.stl | 2.2KB | |
| Divider_200mm.stl | 2.2KB | |
| Divider_50mm.stl | 2.2KB | |
| Divider_75mm.stl | 2.2KB | |
| L-connector.stl | 285.3KB | |
| T-connector.stl | 342.7KB |
