The file 'Drawer Latch – Side Mounted 3D Printer Model' is (FCStd,iges,stl) file type, size is 1.2MB.
End Caps for Open V-Slot 2020 with Open Hardware logo.
This is a remix from https://www.thingiverse.com/thing:398515
I projected a 2d sketch of the male and female latch parts in FreeCAD and then built to the unique geometry of my garbage pullout drawer with only 1/2 inch gap. I needed a side mount because the back of the cabinet is exposed and I couldn't drill into it without risking having the screws pop out of the finished wood.
I counter sunk the holes for sheetrock screw on both sides so you can mount on left or right. I mounted the P-latch in the back left corner against the side wall and mounted the V-latch to drawer itself.
By the way, it isn't necessary to drill screws into all holes on the P-latch. I placed several in case I wanted to stagger things.
| P_latch_-_half_inch_wide.FCStd | 644.8KB | |
| P_latch_-_half_inch_wide.iges | 286.1KB | |
| P_latch_-_half_inch_wide.stl | 64.5KB | |
| V_latch_-_half_inch_whide.iges | 225.2KB | |
| V_latch_-_half_inch_wide.FCStd | 500.9KB | |
| V_latch_-_half_inch_wide.stl | 56.8KB |
