I found that the original battery holder printed in TPU was prone to ripping around the screw holes and the battery positioned in a really exposed way.
I decided to model this holder to mount at the bottom that has a snug fit with the battery and 2 support beams with a flat underside to make launching the drone easier. Also the battery has a small offset to the drone so it does not touch any screws etc.
The micro usb port is still accesable and it can just be mounted with original nuts.
You can add a rubber band but its not really needed because of the snug fit.
I was thinking of also adding prop guards in the same design but decided not to since I don't really like the look of it.
Print settings of relevance:
Printer:
Layer height: .28
Infill: 20%
support: Yes
support overhang: 45*
I am starting youtube so I would appreciate if you would take a look:
https://www.youtube.com/@reinsaris
| battery_drone_v2.stl | 72.3KB |
