I made higher legs to fit my sink.
I made the roof in the tube flat => when preparing in cura, set a no support zone in the tube, and also between the legs. The bridge is easy, no support needed with my modifications. You still need good support under the head. use surface support from cura.
I also added a part to be printed flat and glued in the middle, that avoid the cuttlery to have too much angle. You can print it separately in using fusion 360 i include the file here.
| ELEPHANT-LOW-POLY-Mattxfr.stl | 20.0KB | |
| ELEPHANT-LOW-POLY_v5.f3d | 143.6KB |
