Dry your cutlery in this sink-side elephant.
Place Jumbo so his trunk hangs over the edge and the water drips into the sink.
In design of Version 2 (V2).
I've increase height of the trunk : which allows to be maximum 2cm (or 0.78 in) above the sink ledge.
I also reduced the size inside for stabilize the elephant.
Finally I increase the size of the base of the feet to increase stability.
If you find this useful, please consider tipping a Beer, a pack of Beers or a keg of Beers ;-)
https://www.paypal.me/rudyexplor
Thank you very much if I can drink to your health.
| ELEPHANT-hIGH-POLY.stl | 29.4MB | |
| ELEPHANT-LOW-POLY.stl | 11.8KB | |
| elephant.stl | 2.4MB | |
| V2-ELEPHANT-HIGH-POLY-1.stl | 279.0KB | |
| V2-ELEPHANT-hIGH-POLY-2.stl | 4.3MB | |
| V2-ELEPHANT-LOW-POLY.stl | 11.8KB |
