Hey, I'm glad you found my Dragon Egg Lamp.
You will need to buy a lamp socket and a bulb to assemble this.
EU Plug:
https://ebay.us/PRcPvm
US Plug:
https://ebay.us/hBRN1i
Enhance the ambiance with the perfect bulb:
Print Settings:
You need the Egg and the holder, to assemble them like you can see in the last picture.
Egg: Use a 0.4 mm Nozzle! or a line height of 0.2 mm and a width of 0.4 mm.
Domes are quite hard to print. I always slow down the layers at the top to 50% print speed (at layer 670).
Use 100% infill with concentric infill, or set your wall count to something ridiculous like 40.
Any Basic white PLA will do the job just fine. I used Sunlu White PLA+ if that helps. Don't try Matte or glitter stuff, it will not work.
I use a brim of 10 lines to get this to stick.
It prints 16 hours for me. Be patient. The nose usually scrapes the print at some point but that's kinda normal. This happens because the curve of the print creates a spring effect.
No supports!
Holder: Print with supports.
Happy printing!
That's it. Enjoy your Lamp. :D If you made one, please consider Buying me a coffee at https://www.buymeacoffee.com/Ri0m0
I'm a poor student in need of filament.
| Dragon_Egg_Lamp.stl | 16.9MB | |
| Holder.stl | 105.4KB |
