I liked the design of the original Dragon Dice Tower, but couldn't remotely hope to fit it on my resin printer. As such I split it into five pieces + the roof, which was just enough to fit while keeping it at 100% scale.
Most of the pieces can be printed at relatively sane angles, but for my printer the bottom tower section had to be set at an almost perfect 90% angle to fit. If you have a larger resin printer this shouldn't come up as an issue, but if not make sure you have your resin settings dialed in as much as possible.
| dragon_dice_tower_roof_fixed.stl | 106.9KB | |
| odt_bottom_fixed.stl | 1.7MB | |
| odt_middle_combined_fixed.stl | 3.1MB | |
| odt_top_fixed.stl | 3.4MB | |
| odt_tray1.stl | 118.6KB | |
| odt_tray2.stl | 110.4KB |
