A double sided drill bit tool in various designs.
The bit interface is an interference fit to hold the bits in place. Use a hammer or (better) a vice to press the bits in. You may need to scale the model up or down to get a good fit, depending on your printer and settings. Or just scale up and glue the bits in
Design by: http://www.bokehdesign.at/
| DoubleBitTool1.stl | 2.8MB | |
| DoubleBitTool2.stl | 421.9KB | |
| DoubleBitTool3.stl | 177.2KB | |
| DoubleBitTool4.stl | 2.3MB | |
| DoubleBitTool5.stl | 2.1MB | |
| DoubleBitTool6.stl | 247.0KB |
