Double Bell PEQ 11.1v Extension 3D Printer Model
The file 'Double Bell PEQ 11.1v Extension 3D Printer Model' is (STEP,STL) file type, size is 10.7MB.
The file 'Double Bell PEQ 11.1v Extension 3D Printer Model' is (STEP,STL) file type, size is 10.7MB.
This is an extension to allow the pictured Double Bell PEQ to fit a 105mm 11.1 volt lipo battery. It uses pins made from @3mm diameter bamboo barbeque skewers sections. Glue them in and cut them off at a reasonable length as you assemble it.
| Knob_Pinx2.STEP | 25.2KB | |
| Knob_Pinx2.STL | 1.3MB | |
| PEQ_ExtensionFB.STEP | 833.4KB | |
| PEQ_ExtensionFB.STL | 3.5MB | |
| PEQ_ExtensionFT.STEP | 926.1KB | |
| PEQ_ExtensionFT.STL | 3.6MB | |
| PEQ_ExtensionRB.STEP | 1.3MB | |
| PEQ_ExtensionRB.STL | 5.0MB | |
| PEQ_ExtensionRT.STL | 5.0MB | |
| PEQ_Extension_RT.STEP | 1.4MB | |
| Rear_PEQ_Knob.STEP | 513.0KB | |
| Rear_PEQ_Knob.STL | 3.1MB | |
| Wire_Exit_Knob1.STL | 2.1MB | |
| Wire_Exit_Knob2.STL | 2.2MB | |
| Wire_Exit_Knob_half1.STEP | 514.5KB | |
| Wire_Exit_Knob_half2.STEP | 544.7KB |
