DotBotS – Support For Arduino UNO And Breadboard Used To Create Small Robots 3D Printer Model
The file 'DotBotS – Support For Arduino UNO And Breadboard Used To Create Small Robots 3D Printer Model' is (stl) file type, size is 121.8KB.
The file 'DotBotS – Support For Arduino UNO And Breadboard Used To Create Small Robots 3D Printer Model' is (stl) file type, size is 121.8KB.
Support for Arduino UNO and breadboard to make the first experiments with Arduino.
The support can be used as a small robot.
DotBot S has been used at school to teach coding to primary school students.
This project is the small version of the project DotBot http://www.thingiverse.com/thing:1441937
Since it is an open source platform the robot can be freely modified, copied, and shared across the Internet.
In addition, it is extremely cheap, in fact the cost almost exclusively determined by the cost of servo motors, electronics and sensors.
This work has been created by two professors:
Michele Maffucci - IIS Galilei Ferrari - Torino - Italy
Ludovico Russo - Researcher - Politecnico di Torino - Italy
Hardware:
1 x chassis
1 x battery holder
2 x Ball Caster
1 x breadboard holder
14 x nut M3
14 x screw M3x10 (or M3x5)
2 x glass marbles (diameter 16 mm)
Disclaimer:
This project and all other published material cannot be considered as a final product of DotBot-io and DotBot-io takes no responsibility of its use.
| DBS-ball-caster.stl | 111.4KB | |
| DBS-blocco_batteria_9v.stl | 8.1KB | |
| DBS-dist-40mm.stl | 31.2KB | |
| DBS-ruota-servo.stl | 161.7KB | |
| DBS-struttura.stl | 173.4KB | |
| DBS-supp-servo.stl | 27.7KB |
