Door Latch For T70E’s Ultimaker 3 Door 3D Printer Model
The file 'Door Latch For T70E’s Ultimaker 3 Door 3D Printer Model' is (STL) file type, size is 12.0KB.
The file 'Door Latch For T70E’s Ultimaker 3 Door 3D Printer Model' is (STL) file type, size is 12.0KB.
A door latch addition to T70E's Ultimaker 3 Door at https://www.thingiverse.com/thing:2615653
Thank you T70E for your great door design!
This latch system mounts just like the hinge mounts, but it's a mirror of the original part with some changes to make a dovetail for the slider part. In keeping with the original design, it uses screws already on the Ultimaker.
The slider part is pushed to the right to open the door, left to hold it closed.
I designed this to be printed with a 0.5mm nozzle, so if you print it on an Ultimaker with a 0.4mm nozzle, you may want to adjust the scale of the slider part a tiny bit to compensate for the lesser amount of horizontal expansion from the smaller nozzle. Ideally, there should be a bit of friction between the slider and the mount part, so the slider stays put. Scale only the slider part to adjust the fit (because the mount part has to align with the screw placements).
| UM3DoorLatchMount.STL | 40.1KB | |
| UM3DoorLatchSlide.STL | 18.1KB |
