Dood Shield 3D Printer Model
The file 'Dood Shield 3D Printer Model' is (stl) file type, size is 1.3MB.
The file 'Dood Shield 3D Printer Model' is (stl) file type, size is 1.3MB.
This is a battery powered ventilating face shield.
It requires:
12x12 inch plastic sheet around 6 mil
a 3 volt motor
2 sets of aaa battery contacts
a small piece of HEPA or MERV filter
1 inch strap
20 gauge wire
Soldering equipment
non stretch cotton/ polyester fabric
| battery_cover_left.stl | 4.2KB | |
| battery_cover_right.stl | 4.2KB | |
| brim_bottom.stl | 491.1KB | |
| brim_motor_cradle.stl | 573.6KB | |
| brim_top.stl | 901.9KB | |
| cheek_brace_left.stl | 12.7KB | |
| cheek_brace_right.stl | 12.7KB | |
| dood_shield_logo.stl | 478.8KB | |
| fan.stl | 537.1KB | |
| frame_edge.stl | 549.9KB | |
| strap_adjuster_left.stl | 35.6KB | |
| strap_adjuster_right.stl | 35.6KB | |
| straw_port_door.stl | 9.5KB | |
| straw_port_top.stl | 41.2KB | |
| switch_left.stl | 12.8KB | |
| switch_right.stl | 12.8KB |
