Large bed for dolls designed to be extra sturdy with drawers and middle leg acting as support, Barbie, Ken and 11 friends can have a party on top and it shouldn't budge as the headboard/drawers/middle legs/footboard are all providing support!

Glue WILL be required to join all the components
Sanding should NOT be required
The drawer file does NOT have an initial as in the final photos, the included drawer is blank

Barbie Option: There are 2 sets of middle "bed" part, one is longer than the other and labeled as such. The longer one should fit 11.5" barbie laying flat but I did not print that one so I cannot confirm or deny. In the standard length bed the normal 11.5" Barbie has to sit very slightly upright (like lean on a pillow) then she fits fine. This is shown in the final photos.

Full assembly will require the following:
4 - Drawer Fronts
4 - Drawers
2 - Drawer Frames
1 - Front half of bed
1 - Rear half of bed
1 - Headboard
1 - Footboard

Everything above needs glue, I recommend simple gorilla super glue & cheap clamps to let things dry, any other epoxy works fine as well.

Everything was printed without supports, in many jobs of course so things can lay flat. All of it fit on my Ender 3 bed just fine in separate jobs of course.

I used 20% infill on everything
printed with PLA at 200 / 60
50mm print speed