Basic doghouse - made from 2 elements.
This one is quite big - as the dog was big....
To print - for bottom part - small support is only needed for the dog entry. But if you use good quality PLA with cooling - I think even no support should work fine.
I did use support - but found that is was not necessary.
For roof part - you need only support on the outer edge - the roof is standing on the main part with 2mm expansion - so you need some support around that. No support needed to keep the roof - it should go fine without support there.
Now I think the roof could be little re-designed to avoid support at all - but as I have this already printed - there is no need.
Source files are attached - Cubify Invent. So you can change the name if needed. Or add own elements.
So just to mention - minimal support is needed.... only for 2 mm around and entry.
| Buda.FUN | 3.4MB | |
| Buda.stl | 708.7KB | |
| Buda_kosc.FUN | 604.5KB | |
| Buda_kosc.stl | 1.7MB | |
| Daszek.FUN | 1.2MB | |
| Daszek.stl | 170.0KB |
![3D Printable Pallet Town [ Pokemon! ] 3D Printer Model](https://cdn.3axis.co/assets/45/ee/aa/1c/45eeaa1c-18b3-46e5-8ceb-26b23a7521c7/images/21cf5b03-7f07-4037-ae00-fd726bccba7d_thumb.jpg)
