Dog Biscuit Roller – Paw Print Design 3D Printer Model
The file 'Dog Biscuit Roller – Paw Print Design 3D Printer Model' is (stl) file type, size is 637.1KB.
The file 'Dog Biscuit Roller – Paw Print Design 3D Printer Model' is (stl) file type, size is 637.1KB.
Here's a roller I designed in TinkerCAD for some homemade dog biscuits I like to make. The roller adds a paw print design to the biscuits and helps give a visual guide for cutting straight lines as well. Please print with food safe filament.
The roller didn't need to be all that long because I only make so many biscuits at one time. I think it took around three rolls to cover the whole sheet of biscuits with the design imprint. The design allows enough room to make nice cuts above & below as well as on each side of the paw print. The treats I make are for my 25lb & 35lb dogs. You might want to size the roller larger or smaller depending on the size biscuits you would want.
I used this recipe for the biscuit mix:
https://www.spendwithpennies.com/pumpkin-dog-treat-recipe/print/
It's nice because the mix is thick enough to hold the paw imprint during the bake.
This is the my first original creation I'm publishing on Thingiverse! Please post a picture of your print or biscuits if you make it.
Treat your pups to some homemade biscuits :)
Enjoy!
| DogBiscuitRoller.stl | 1.6MB |
![Slinky [Toy Story] 3D Printer Model](https://res.3axis.co/ffd959c8-2302-41a1-8513-dd7a610a34b2/images/25cc1f87-4dd0-4aad-85c3-6b7012958ed5_thumb.jpg)
