Dodge Charger Front And Rear Badges (2006-2010) 3D Printer Model
The file 'Dodge Charger Front And Rear Badges (2006-2010) 3D Printer Model' is (stl) file type, size is 7.5KB.
The file 'Dodge Charger Front And Rear Badges (2006-2010) 3D Printer Model' is (stl) file type, size is 7.5KB.
Front and rear badges for 2006-2010 Dodge Charger.
Attach using 3M emblem adhesive tape. The front emblem will need an extra layer of tape on the left and right side due to the mounting being slightly different than the original emblem. For the front you will also need to cover the hole that the original emblem used to mount ( I used a few layers of vinyl wrap and it looks fine).
I may make a plate for the front emblem at some point so it will mount like the original. That is why this is listed as a work in progress.
After printing I suggest sanding, adding a little bondo if the top layer has any defects, and painting the emblem before installing it. I did not use bondo so i have a few blemishes near the center of my badge.
| Dodge_logo_F.stl | 57.1KB | |
| Dodge_logo_R.stl | 57.5KB |
