Dobelman D20 Of Holding 3D Printer Model
The file 'Dobelman D20 Of Holding 3D Printer Model' is (stl) file type, size is 2.4MB.
The file 'Dobelman D20 Of Holding 3D Printer Model' is (stl) file type, size is 2.4MB.
This is not a Remix, but very much inspired by https://www.thingiverse.com/thing:105296 and https://www.thingiverse.com/thing:1610141
Numerical faces are aligned to be used as a countdown die. The Top seam shouldn't snag or over hang when closed. There is a little notch between 16/20 along the edge that should help easily line the lid up. It was also intended to help lift the lid when opening. However i found that sliding the top across the magnets was much better and more gratifying than lifting it straight up.
Picked up the magnets from the local Michaels.
https://www.michaels.com/promag-neodymium-magnets/10413548.html
.25in - 6.3mm
Printed with Makergeek Royal Purple ABS. I did have a couple of minor splits in my print. And used a thick ABS slurry as glue to hold the magnets in. Which i have a feeling, since the magnets are so smooth may pop out some day soon. Should have super glue'd em.
I'd love to see this printed with a better (or better adjusted) printer.
| Bottem_Dobelman_D20_of_Holding.stl | 3.9MB | |
| Top_Dobelman_D20_of_Holding.stl | 1.5MB |
