I made a version two for this shield. Version 2 has a better connection for the small gears in the assembly. I was also able to reduce the number of parts. Find the new shield design here: https://www.thingiverse.com/thing:4990382.
I designed this shield for a friend that I play D&D with. The shield has a simple gear system on the back to open up the central compartments. Spinning the large gear on the back of the shield will cause the 3 circles on the front of the shield to spiral out, revealing the dice beneath. These holes are spaced out to fit a set of 7 dice - d20, d12, d10, d8, d6, d4, & percentile.
The main body of the shield was split into two parts so that it could fit on my print bed. Each of these parts halves was printed using multimaterial, 3 extruders. The tolerancing was tight enough to hold the two halves together.
Glue was needed to connect the top and bottom halves of the 3 gear plugs.
Parts were printed with 20% infill and 0.15mm layer height. Supports were only used for the 3 shield symbol parts and the central dice holder. This print was made in PLA.
Check out the sword I made, here: https://www.thingiverse.com/thing:4829524
Check out the hammer I made, here: https://www.thingiverse.com/thing:4960893
| Dice_Slots__Bezel.STL | 66.9KB | |
| Gear_Spacer_-_Need_3x.STL | 21.2KB | |
| Large_Gear.STL | 554.7KB | |
| Large_Gear_Plug.STL | 28.9KB | |
| Shield_Body.STL | 1.1MB | |
| Shield_Symbol_-_Need_3x.STL | 58.6KB | |
| Small_Gear_-_Need_3x.STL | 187.9KB | |
| Small_Gear_Plug_-_Need_3x.STL | 39.3KB |
![Giant Scholar [EVERYDAY HEROES] 3D Printer Model](https://res.3axis.co/a0939153-165f-41ae-996e-5ad25a4f27d1/images/aa03efa6-381c-4e72-b5ca-a56d4fb5660f_thumb.jpg)
