A "remix" of abrokadabra's DNA Earring
I recreated it in OpenSCAD to close the top of the earring to allow it to attach to a small earring ring.
It's as close as I can get to to abrokadabra's without doing too much
The OpenSCAD has a lot of hard coded numbers but it could serve as a jumping off point if you wanted to customise it further. abrokadabra's version worked really well on a resin printer. I suspect this version will not work well on an FDM printer - but I could be wrong!
I did also dip the prints in wood varnish which helped bring out the clear nature of the resin
| circularDNAHelix.scad | 1.5KB | |
| circularDNAHelix.stl | 4.5MB |
