Travel case for DJI Neo. The lid is just a tension fit.
If you use the version with the magnet. You will need 2 5mm x 2mm round magnets. Glue them in the provided holes with proper polarity.
On the side opposite of the magnet I hot glued a 4 inch strip of 1/2" elastic as to keep the the lid tight and secure. First glue the elastic to the inside of the lid. Then stretch it some while you glue and hold it to the inside of the main case. Hold it while it cools.
I used a 2mm thick piece of craft foam inside the case to add extra soft area for the drone. This is optional.
| Neo_Case_Magnet_Bottom.stl | 294.7KB | |
| Neo_Case_Magnet_Top.stl | 213.9KB | |
| Neo_Travel_Case_Bottom.stl | 275.7KB | |
| Neo_Travel_Case_Top.stl | 194.3KB |
