Having discovered Litchi could enable Follow-Me on my DJI Mini 2, I wanted to get it to follow me on my motorbike, but the thought of juggling the controller was a bit daunting.
As I already have a RAM X-Grip for my phone mounted, I used that to hold the base and created a clip for the controller.
To make printing simple (and allow you to remix your own mount), I've created 2 parts - the clip and the mounting block and using 2xM5x15mm screws to tie them together.
A word of warning, the clip attaches very firmly (which is comforting). I found I had to undo the cables on the controller to roll the clip off the end of the controller.
BTW The print quality is very draft, I will take it for a test run, and then print it in a higher quality and using PTEG.
| Drone_Bracket-Base.stl | 32.7KB | |
| Drone_Bracket-Clip.stl | 59.5KB |
