DIY WiFi RGB LED Soft Lamp 3D Printer Model
The file 'DIY WiFi RGB LED Soft Lamp 3D Printer Model' is (STL,zip) file type, size is 13.8MB.
The file 'DIY WiFi RGB LED Soft Lamp 3D Printer Model' is (STL,zip) file type, size is 13.8MB.
This lamp is almost whole 3D printed, including the light diffuser other parts cost about 10$. It has lots of preconfigured light animation effects and static light colors with autoplay loop feature. Lamp stores last used setting to the internal memory, so it could be configured once and used like usual lamp with power switcher. No app required, it could be controlled by using any device where browser is available. It also can operate in 2 modes, as standalone and part of home WiFi network.
Supplies:
• 1 x Double Side Prototype PCB 4*6 cm
• 1 x HLK-PM01 AC-DC 220V to 5V Step-Down Power Supply Module or something similar
• 1 x Wemos D1 Mini WiFi Development Board Micro USB
• RGB I2C LED strip with 60 LEDs/m
• 4 x M3 nuts
• 2 x M3x6 screws
• 5 x M3x12 screws
• power cord with plug and switcher on it
• some jumper wires
• 3 x header pins
• soldering tools
• 3D printer with Clear and Black filament
Assembly instructions are stored here https://www.instructables.com/id/DIY-WiFi-RGB-LED-Soft-Lamp/
| LampBase.STL | 11.9MB | |
| LampBaseLid.STL | 4.3MB | |
| LampCableClamp.STL | 2.5MB | |
| LampDiffuser_VASE_MODE_.STL | 609.5KB | |
| LampElectronicsHolder.STL | 13.1MB | |
| LampLEDTower.STL | 1.5MB | |
| MagicLamp.zip | 1.2MB |
