Remix from Makerbot's Drive block adapted for DIY PrintRite using original parts, and fit with the hot tube teflon cap.
You will need a few extra screw
1 x M3 x 4mm
1 x M4 x 10mm
2 x M3 x 4mm longer screws for the nema mounting (i use 43mm screws)
NOTE : there is a support under the base (center)
| Spring_loaded_004_Base.stl | 7.2MB | |
| Spring_loaded_004_Base_Mirrored.stl | 1.9MB | |
| Spring_loaded_004_Cover.stl | 913.8KB | |
| Spring_loaded_004_Cover_Mirrored.stl | 262.1KB | |
| Spring_loaded_004_Lever.stl | 7.2MB | |
| Spring_loaded_004_Lever_Mirrored.stl | 1.8MB |
