DIY Power Bank Case 3D Printer Model
The file 'DIY Power Bank Case 3D Printer Model' is (stl) file type, size is 1.1KB.
The file 'DIY Power Bank Case 3D Printer Model' is (stl) file type, size is 1.1KB.
I decided to make my own High Capacity Power Bank. For this, I used 3 6,000 mah 18650 li-ion batteries(for a total capacity of 18,000 mah) and a usb and micro usb board to charge the batteries and to charge my phone with the power bank. I made this case to fit 3 of those 3.7v batteries and there is room for wires and room for the Circuit board. It is a nice and compact case with easy access to thte batteries and board if needed. You may have to sand out the hole for the USB port a bit depending on the size but most likely not as they are all usually around the same size. I also did not make a hole for the wires from the batteries to the USB so you will have to cut that out as well. Hope you all enjoy this and feel free to leave a tip because I am a High-school student making these for fun and I am trying to save for college. Thanks:)
| power_bank_base_v1.stl | 3.2KB | |
| power_bank_lid_v1.stl | 1.4KB |
