DIY Monitor 3D Printer Model
The file 'DIY Monitor 3D Printer Model' is (stl) file type, size is 1.4MB.
The file 'DIY Monitor 3D Printer Model' is (stl) file type, size is 1.4MB.
The STL in preview may look broken, but in slicers (eg. PrusaSlicer), they look fine;
You may have to adjust the box and frame for your display and board to fit properly
and you need 4 metal screws for plate assembly which are NOT in the models.
Mine display is about 16", but make sure to adjust the model to your display, board and desk sizes.
The vice and screw was made by redesigning mistertech's on Thingiverse model (licensed under https://creativecommons.org/licenses/by/4.0/)
| base.stl | 524.8KB | |
| base_screw.stl | 218.1KB | |
| base_vice_screw.stl | 218.2KB | |
| frame1.stl | 3.0KB | |
| frame2.stl | 2.8KB | |
| frameholder.stl | 44.2KB | |
| holder.stl | 124.2KB | |
| plate.stl | 34.7KB | |
| screw.stl | 1.8MB | |
| vice.stl | 542.4KB |
