DIY Jewelry Box 3D Printer Model
The file 'DIY Jewelry Box 3D Printer Model' is (stl) file type, size is 2.4MB.
The file 'DIY Jewelry Box 3D Printer Model' is (stl) file type, size is 2.4MB.
As it as a box for jewelry, it can be a nice gift for your girlfriend or your mom.
I suggest to print the "Top Cover" at a standing position (at low speeds) as it has small details - also put a raft below it to have enough build plate adhesion.
The "Base" can be printed upside down - it is optional. You can calculate the amount of support needed in both position.
The "Leg" and the "Buttons" are small so don't print them 1 by 1.
As i drawed the model with tight tolerances the physical part can be too tight and the drawers will move hardly - as an option you can try to resize the drawers or sand them until it will move freely.
For the assembly i used epoxy, to glue them together.
| Base.stl | 2.2MB | |
| Big_Drawer.stl | 92.1KB | |
| Bottom_Plate.stl | 44.8KB | |
| Button.stl | 1.0MB | |
| Leg.stl | 946.3KB | |
| Small_Drawer_1.stl | 34.1KB | |
| Small_Drawer_1_1.stl | 52.6KB | |
| Small_Drawer_2.stl | 34.1KB | |
| Small_Drawer_2_2.stl | 52.6KB | |
| Top_Cover.stl | 3.9MB |
