DIY GENIRIS Scanner 3D Printer Model
The file 'DIY GENIRIS Scanner 3D Printer Model' is (stl,pdf) file type, size is 20.9MB.
The file 'DIY GENIRIS Scanner 3D Printer Model' is (stl,pdf) file type, size is 20.9MB.
The purpose of this version is to provide increased adjustment possibilities, as well as to have a reduced manufacturing cost.
The electronic components and software used are the same as the Ciclop, which inspired us. Thank its designer for the quality of his work, as well as the community that supported him.
Features:
Adjustable camera height (65mm)
Adjustable camera tilt (20°)
Reduced printing volumes.
Few support material required
Platform supported by 3 (low cost) ball bearings.
Reduced NEMA 17 motor height (28 mm)
Easy assembly
Open source board ZUM
Open source firmware Horus-fw Horus-fw
Open source multi-platform software Horus Horus.
More free 3D files: www.genapart.com
Listing:
Aluminium tube Ø12 x 350 mm x2
Aluminium tube Ø12 x 105 mm x2
Aluminium tube Ø12 x 145 mm x2
Acrylic plateform Ø200 x 3 mm x1
Acrylic pattern holder 160 x 100 x 3 mm x1
Camera Logitech C270 x1
NEMA 17 Motor 28 mm height x1
UNO Board x1
ZUN Board x1
A4988 Stepper Motor Driver x1
DC 12V 3A Power Supply Adapteur x1
5mw red line laser module MXD1230 x2
623ZZ Bearing Ø3 x Ø10 x 4 mm x3
M3 Nut x8
Ø3,2 x Ø6,8 x 0,6 mm Washer x11
FHC M3 x 8 mm Screw x3
TBHC M3 x 6 mm Screw x4
TBHC M3 x 10 mm Screw x5
TCB POZI 3 x 16 mm Screw x1
TCB POZI 3 x 10 mm Screw x14
Dupont Wire 4 pins female to individual male 50 cm x1
Dupont Wire 2 pins female to male 40 cm x2
USB Wire A to B x1
| Box.stl | 9.0MB | |
| Box_Cover.stl | 1.7MB | |
| Camera_Holder.stl | 2.3MB | |
| Camera_Housing.stl | 7.4MB | |
| Camera_Housing_Clamp.stl | 2.7MB | |
| Damier_13_x_13.pdf | 66.1KB | |
| Disc_Holder.stl | 6.0MB | |
| Laser_Clip.stl | 1.3MB | |
| Left_Laser_Holder.stl | 3.1MB | |
| Left_Pattern_holder.stl | 1.6MB | |
| Left_Z_Clip.stl | 563.9KB | |
| Listing.pdf | 370.8KB | |
| Motor_Holder.stl | 7.5MB | |
| Right_Laser_Holder.stl | 3.1MB | |
| Right_Pattern_holder.stl | 1.6MB | |
| Right_Z_Clip.stl | 563.9KB | |
| Tube_Clip.stl | 1.0MB |
