DIY Filament Vacuum Bag 3D Printer Model
The file 'DIY Filament Vacuum Bag 3D Printer Model' is (stl) file type, size is 1.8MB.
The file 'DIY Filament Vacuum Bag 3D Printer Model' is (stl) file type, size is 1.8MB.
This is a remix of 310Blacksmiths Vavle for creating a sealable filament bag. I made the boss vavle top part shorter so you can screw on the cap i created for better sealing because i found that no matter how hard you tighten the boss valve it still lets air out/in.
Print everything in PLA or ABS.. doesnt really matter/ However if you want better sealing i would print the little valve insert in TPU or try to fit a rubber sealing gasket inside.
I included the original files, my addon files are under Vacuum_Vavle_Edit
Use a really thick Zip Lock Bag that seals very well.. Thicker the better
Cut a hole where you want the valve. (you can also use a little rubber gasket between the 2 parts sealing the bag or a tpu printed gasket.
It does loosen up a little bit but i think it was because of the type of cheap zip lock bag i was using rather then the valve itself
This is by far one of the best DIY Valves for creating a filament storage bag that ive seen/tried, so Kudos to 310Blacksmith
| Vacuum_Bag_Base.stl | 2.3MB | |
| Vacuum_Bag_Valve_Nut.stl | 539.8KB | |
| Vacuum_Bag_Valve_Valve.stl | 138.8KB | |
| Vacuum_Bag_Valve_Valve_Boss.stl | 910.5KB | |
| Vacuum_Valve_Edit.stl | 213.4KB |
