Here is Version 3 of my attempt to print a storage solution for Dixit, the board game by Libellud.
This was printed on my 6" Printrbot (the ItsyBitsyPrintsy), so It should be small enough for those of us with smaller printers.
It prints in 12 pieces. Left side and right side each have 5 slanted pieces with bottoms and stabilizing walls, and an additional piece in which to store player tokens.
The space between each slat is meant to hold 84 cards, unsleeved. There is a little bit of a gap, so if you have the promos, you can probably finagle a couple extra cards in each slot.
This version has left and right copies, so the stabilizing wall is against the cardboard and all the cards are facing the same direction. Depending on preferences, you can just print one side's version twice and flip them so the cards are slanted in opposite directions.
**I had to print the Token holders with "Combine everything(type-a)" unchecked in Cura > Expert Settings > Fix horrible.
| backend_left.stl | 32.6KB | |
| backend_right.stl | 37.5KB | |
| frontend_left.stl | 34.5KB | |
| frontend_right.stl | 36.7KB | |
| middle_leftx3.stl | 34.3KB | |
| middle_rightx3.stl | 42.9KB | |
| playerpiecesx2.stl | 110.3KB |
