The design was done for a competition at our local maker space - (http://www.binaryspace.co.za/). The competition was divided into 2 challenges:
Challenge Part 1:
Design a single sided pcb that functions as a clock.
Challenge Part 2:
Design a 3d printed enclosure for a 10cm in diameter clock pcb.
This clock was designed by me, and inspired by the Disneyland castles. It has space for a 10cm round clock face and all batteries, electronics and clock mechanisms are housed inside the square body of the castle.
For my build, I also put small pictures of shadows of the Disney characters in the windows, and they are lit with high bright LED's so it doubles as a nightlight.
The whole project was 3D printed and spray painted afterwards. I also included a pdf with the design I created and etched on the pcb for the clock face.
My husband also created an entry: http://www.thingiverse.com/thing:1586350
| Assembly_Drawing.PDF | 154.7KB | |
| Back_Wall.STL | 41.2KB | |
| Big_Tower_Room.STL | 108.1KB | |
| Castle_Bottom.STL | 51.1KB | |
| Castle_Top.STL | 51.1KB | |
| Clock_Face_Rim.STL | 200.1KB | |
| Front_Wall.STL | 60.1KB | |
| Large_Helix_Tower_Roof.STL | 2.5MB | |
| Minnie_Mouse_Clock_Face.PDF | 378.1KB | |
| Side_Wall.STL | 39.2KB | |
| Small_Helix_Tower_Roof.STL | 2.0MB | |
| Small_Tower_Room.STL | 99.4KB | |
| Tower_100mm.STL | 31.2KB | |
| Tower_150mm.STL | 26.2KB | |
| Tower_150mm_Slotted.STL | 28.1KB | |
| Tower_180mm_Slotted.STL | 28.0KB | |
| Tower_Topper.STL | 110.0KB |
