This is a discreet face mask holder which will free your ears from those uncomfortable strings.
I designed it for easy length adjustment (two parts) and to save material. Unlike the most commonly used straps this holder becomes part of your mask and does not come off by itself when you don´t use it (while still detachable). One pair will only cost you about 1g of filament and 5 to 10 minutes of printing time.
Attach both parts to the strings on each side of the mask. To do so guide the loop end through the round hole and put it over the entire part. Then just pull to automatically tie a knot. Make sure that the tooth of part 2 is on the outside and points away from your neck!
BE SAFE and consider sharing your make with the community!
| mask_holder_part_1.stl | 49.1KB | |
| mask_holder_part_2.stl | 45.8KB |
