Discobolus No Support (The Discus Thrower) 3D Printer Model
The file 'Discobolus No Support (The Discus Thrower) 3D Printer Model' is (stl) file type, size is 12.8MB.
The file 'Discobolus No Support (The Discus Thrower) 3D Printer Model' is (stl) file type, size is 12.8MB.
Do you hate support and the scars removing it leaves on a beautiful model? Do you love smkmuseum's elegant scan yet feel reluctant about printing it because of the tremendous amount of support needed? This may be the solution! I carefully cut the model into six pieces so each piece can be printed perfectly without any support. All parts are already oriented correctly. In addition a plate file that contains all parts is provided. I scaled the model down to 12% (No detail is lost in downscaling). I also cut a thin layer off the original scanned base as it was neither flat nor level.
Gluing the model up should be straightforward, but a minor warning: consider using E6000 (a type of shoe glue) instead of superglue; the latter may dry too quickly for you to make fine alignment adjustments.
Also check out my Muscular Discobolus no support version http://www.thingiverse.com/thing:2042991
| arm.stl | 1.0MB | |
| hand.stl | 285.7KB | |
| head.stl | 1.0MB | |
| plate.stl | 11.8MB | |
| torso1.stl | 1.5MB | |
| torso2.stl | 7.8MB | |
| wrist.stl | 107.5KB |
