DESCRIPTION

These are wall-mounted brackets to make disc shelves in combination with 3/4" dowels or similar rods. They are large enough to fit large-diameter midranges (180g class), all drivers, and putters.

Update 1/16/22: Cleaned up my CAD. Removed unnecessary material around the rod supports on L and R. Removed vertical printing chamfers on M rod holes: Vertical printing not recommended. Added pilot hole and countersink for 1/2" countersunk wood screws to hold dowels in place on L and R brackets.

PRINT SETTINGS/FILAMENT

Supports not required
Print laying flat
2mm wall thickness, infill ~15% or higher. Want more strength? MORE WALLS!
PLA (NOT SILK), ABS, PETG, tested successfully. I do NOT recommend SILK or any other shiny PLA due to weak layer adhesion.

INSTALLATION

You can use one of each for a shelf, or three "middle." If you use 3 "middle" you will lose about 2 discs of storage space per shelf.

I recommend securing the rods to the Left and Right brackets with a 1/2" wood screw for maximum security. Holes are included in the L and R brackets for this purpose, and it is a good idea to pre-drill the dowels or whatever you're using.

I am using blue #10-12 hollow wall anchors to hold 5x 48" shelves in drywall, with one bracket of each shelf in a stud. Pictured is the shelves in my previous house, installed in the same manor onto cinderblocks.