DIN Rail Box For Raspbery PI With HAT And Display 3D Printer Model

Author: @
License: CC BY-NC
File formats: zip,stl
Download type: zip
Size:1.0MB

The file 'DIN Rail Box For Raspbery PI With HAT And Display 3D Printer Model' is (zip,stl) file type, size is 1.0MB.

Summary

raspberry_DIN_rail_box

This is a box for Raspberry PI to be mounted on a DIN rail.

It got room for a standard HAT.

kicad_RPi_HAT.zip

In the kicad files you can find our example HAT complete with schematics. It is intended for applications where the RPi will sit embedded in some place powered from 24 Volts (instead of typical 5 volts) and connected to an ethernet.

prod_gerber_files.zip

This is PCB ready for production, just send it to JLCPCB or similar service. The other components can be found at Digikey. NOTE some components are surface mounted so this is not a project for beginners to start with.

display

On top of our HAT we also had a display:
Displaymoduler - LCD, grafiska Röd, grön, blå (RGB) TFT - färg SPI 1,54" (39,12mm) 240 x 240
https://learn.adafruit.com/adafruit-1-3-and-1-54-240-x-240-wide-angle-tft-lcd-displays/pinouts
digikey:1528-2580-ND

software_show_time_and_IP_on_display.zip

If also using the software here it will show useful things like name, time, temp and IP address on the little display. This will help a lot when installing and setting up the networking.

www.eit.se

The above should be usefull as it is. If you need a custom HAT we can give you an offer to make one for you. Or if you need a custom box of any sort we can give an offer on that too.

Find our email at:
http://www.eit.se/contact/

kicad_RPi_HAT.zip 608.2KB
prod_gerber_files.zip 197.1KB
raspbery_DIN_rail_box_all.stl 1.3MB
raspbery_DIN_rail_box_crossbow.stl 23.8KB
raspbery_DIN_rail_box_left.stl 170.5KB
raspbery_DIN_rail_box_right.stl 1.1MB
software_show_time_and_IP_on_display.zip 27.4KB