Electric Guitar model based on Dean "Dime from hell" STL file is more or less 1:1 scale. For printing I've used 0,35 scale factor, in my opinion it give best results. 0.2 layer for body and 0.1 layer is ok.
To avoid supports, neck is divided in 2 pieces for easier printing. Neck head is flat, so it's good to bend it a little bit using heat.
Check out my other designs:
Ibanez Jem – https://www.thingiverse.com/thing:5026320
Bc Rich Warlock – https://www.thingiverse.com/thing:5103842
Ibanez Iceman - https://www.thingiverse.com/thing:5231125
Fender Stratocaster - https://www.thingiverse.com/thing:2748193
Fender Telecaster- https://www.thingiverse.com/thing:4056363
ESP Explorer - https://www.thingiverse.com/thing:2746802
Gibson Flying V https://www.thingiverse.com/thing:2747925
Gibson Les Paul - https://www.thingiverse.com/thing:2839766
PRS Mark Tremonti - https://www.thingiverse.com/thing:3421690
Gibson Sg –https://www.thingiverse.com/thing:5350017
Dean Rebel – https://www.thingiverse.com/thing:5359480
Jackson RR - https://www.thingiverse.com/thing:5437801
| Dime_Body.stl | 1.3MB | |
| Dime_Neck.stl | 915.9KB | |
| Neck_Base.stl | 185.5KB |
