Dicetower For DSA 3D Printer Model
The file 'Dicetower For DSA 3D Printer Model' is (STL) file type, size is 356.1KB.
The file 'Dicetower For DSA 3D Printer Model' is (STL) file type, size is 356.1KB.
Hi Folks,
this is a dicetower I designed for the german Pen and Paper DSA.
If you don't want the engravings for the stats, just print the "_without_engraving" file, there's also a "_clean" file in which the top of the tower is just flat.
The dicetower and dicecatcher are printed in two seperate parts and can be snapped together in a matter of seconds.
The tower prints with minimal support (just activate support for the bottom cutout). After the print, snap out the two support beams I put where you throw in the dice.
Dicetower and catcher took 48 hours on my Ultimaker 2.
Enjoy!
| dicetower_clean.STL | 127.5KB | |
| dicetower_new.STL | 990.9KB | |
| dicetower_new_catcher.STL | 3.8KB | |
| dicetower_without_engraving.STL | 159.6KB |
