This is a remix in FreeCAD from the original linked model. I did not have the connector that was design for the other model, so I removed part of the piece so that Dupont cables could fix instead.
The lid of the model remains unchanged from the original model.
Print settings are the ones from the original model, you can check it here.
Note that depending on the color you use, some light might be visible from the outside (obviously some light might bi filtered through the slots too).
Folding the DHT11 sensor might reduce a little bit the heat captured from the rest of the electronics reducing a bit the noise in the sensor.
| caja.FCStd | 760.0KB | |
| climate_tracker_box.stl | 33.2KB | |
| climate_tracker_lid_v14.stl | 14.9KB |
