Devil Fruit Herb Grinder V2 3D Printer Model
The file 'Devil Fruit Herb Grinder V2 3D Printer Model' is (stl) file type, size is 10.6MB.
The file 'Devil Fruit Herb Grinder V2 3D Printer Model' is (stl) file type, size is 10.6MB.
Second attempt for a Devil Fruit Herb Grinder, way better than the first one.
(Foco Foco, also available).
I mixed the Gom Gom fruit with a tootless herb grinder.
The project can be improved, that's why I share it, differently from the previous one, this model could be easly printed in any directions, leaving both the grinder and the engraving fine: a major improvement!
The stem has been adapted in size to be able to easily clean what is present in the grooves of the grinder and fit the upper hole.
Modeling obtained by combining these two other models:
Fruit
https://www.thingiverse.com/thing:5418476
Grinder
https://www.thingiverse.com/thing:2088989
The product fits easily in one hand, it does not bother even on a bedside table.
A figure for the most alternative pirates.
Get ready to reach the all blue.
| Base_FruitGrinderV2.stl | 10.8MB | |
| Stem_FruitGrinderV2.stl | 1.9MB | |
| Top_FruitGrinderV2.stl | 11.2MB |
