Check out mekmekmek's customizable version here: http://www.thingiverse.com/thing:188285
Hutch914 put it in the Makerbot customizer, too, if that's your thing.
http://www.thingiverse.com/thing:1096880
Rather than spend time printing springs for a project, I made this little mold to make them out of raw 3mm PLA filament. It measures 3/4" by 3" tall. Since there are no shear planes in this twisted filament, the springs it creates will be a lot tougher than anything printed.
I think this concept could be used to produce torsion springs as well as conical compression springs with different molds.
If you wrapped the filament around a dowel with the sides of the filament touching, you could make an extension spring instead of a compression spring.
| spring_maker.ipt | 726.0KB | |
| spring_maker.stl | 14.8MB |
