Detached Undercarriage For FT Sea Otter 3D Printer Model
The file 'Detached Undercarriage For FT Sea Otter 3D Printer Model' is (stl) file type, size is 51.0KB.
The file 'Detached Undercarriage For FT Sea Otter 3D Printer Model' is (stl) file type, size is 51.0KB.
This is a detachable undercarriage for the Flitetest Sea Otter so you can take off from the ground if you don't have water nearby. The undercarriage does not glue to the aircraft. However, the tail skid glues to the bottom of the tail of the aircraft so it doesn't scrape foam off of the aircraft.
Requires 1mm piano wire rod for the axel and any type of glue
| tail_skid.stl | 1.3KB | |
| undercarrage_pt1.stl | 33.8KB | |
| undercarrage_pt2.stl | 32.9KB | |
| Wheel_Base.stl | 141.7KB | |
| wheel_tread_tpu.stl | 56.3KB |
