This was originally designed to be constructed from 6mm (1/4in) plywood. But if you have a large enough printer, this can easily be printed out using a 20-25% infill for rigidity.
In order to save on overall download time, only 1 copy of each sub assembly part has been uploaded, refer to the assembly PDF files for total quantity of each sub-assembly part needed for completing the project.
Enjoy
| Desk_Organizer_Assembly.pdf |
| Drawer_-_A.pdf |
| Drawer_-_B.pdf |
| DRAWER_A_-_BOTTOM.STL |
| DRAWER_A_-_FRONT.STL |
| DRAWER_A_-_FRONT_INNER.STL |
| DRAWER_A_-_REAR.STL |
| DRAWER_A_-_SIDE.STL |
| DRAWER_B_-_BOTTOM.STL |
| DRAWER_B_-_FRONT.STL |
| DRAWER_B_-_FRONT_INNER.STL |
| DRAWER_B_-_REAR.STL |
| DRAWER_B_-_SIDE.STL |
| DRAWER_PULL.STL |
| Organizer_Body.pdf |
| ORGANIZER_BODY_-_BOTTOM_SHELF.STL |
| ORGANIZER_BODY_-_DIVIDER.STL |
| ORGANIZER_BODY_-_LEFT_DRAWER_GUIDE.STL |
| ORGANIZER_BODY_-_LEFT_DRAWER_SLIDE.STL |
| ORGANIZER_BODY_-_LEFT_SIDE.STL |
| ORGANIZER_BODY_-_MAIN_SHELF.STL |
| ORGANIZER_BODY_-_POCKET_FRONT.STL |
| ORGANIZER_BODY_-_POCKET_LEFT.STL |
| ORGANIZER_BODY_-_POCKET_RIGHT.STL |
| ORGANIZER_BODY_-_RIGHT_SIDE.STL |
| ORGANIZER_BODY_-_SHELF_SPLITTER.STL |
| ORGANIZER_BODY_-_TAPE_SIDE_-_LEFT.STL |
| ORGANIZER_BODY_-_TAPE_SIDE_-_RIGHT.STL |
| ORGANIZER_BODY_-_TAPE_SUPPORT.STL |
| ORGANIZER_BODY_-_TOP_SHELF.STL |
| ORGANIZER_BODY_-_UPPER_SHELF.STL |
| Pen_Holder.pdf |
| PEN_HOLDER_-_CUP_BASE.STL |
| PEN_HOLDER_-_CUP_LEG.STL |
| PEN_HOLDER_-_FRONT.STL |
| PEN_HOLDER_-_REAR_LEG.STL |
| PEN_HOLDER_-_TOP.STL |
| SHELF_B.STL |
