DeltaBot printer Main Body I found when first started 3d Printing think I borrowed most of the parts from an Aliexpress seller but it was open source unfortunately cannot give credit to the creator as they are unknown to me saw no point in re inventing the wheel but it works rather well so I will put it out there.
Added by me Autolevel and Extruder that handles NinjaFlex nicely picture of mine shown not looking its best it works non stop and has already had a hard life.
Added the braces seen at base of collumns adds a lot of stability to printer
Found the store I got the open source STL's from and there are build instructions available on video and in word docs and the software available on site.
http://pan.baidu.com/s/1kTjE7JL#path=%252FDetal%25203D%2520Printer%2520K800-EN%252FDucument
http://pan.baidu.com/s/1kTjE7JL#path=%252FDetal%25203D%2520Printer%2520K800-EN%252FSoftware
Download seems slow so Grabbed doc files edited on site and printed to PDF uploaded for your download
| 2020_channel_cover3.stl | 7.3KB | |
| Build.pdf | 11.0MB | |
| deltabot_glass_clip.stl | 5.4KB | |
| delta_2020_brace1.stl | 36.5KB | |
| Delta_auto_level.stl | 230.4KB | |
| Delta_Belt_fastener.stl | 157.7KB | |
| Delta_Bottom.stl | 391.8KB | |
| Delta_driver_board.stl | 140.0KB | |
| Delta_lcd.STL | 103.8KB | |
| Delta_Limit_switch_3.stl | 31.6KB | |
| Delta_power.stl | 98.7KB | |
| Delta_sliding_shaft.stl | 216.2KB | |
| Delta_Support.STL | 58.7KB | |
| Delta_Top.stl | 1.1MB | |
| Electronics.pdf | 3.0MB | |
| Extruder.stl | 370.2KB | |
| Extruder2.stl | 121.6KB | |
| flextruder175.stl | 389.6KB | |
| Software.pdf | 1.6MB |
