I made this for the WD22TB4 Dell Hub. Comparing a few models it appears the same housing is used. Any docks/hubs with the same dimensions should fit this holder.
I wanted a clean solution to mount this below my desk. This is secure and easily removed from the hub for any reason.
I initially printed on it's side(no supports) however with no brim it lifted slightly. The print is still functional so I will not be printing another. I think printing flat with supports(without might work too) would give a better looking print. I am doubting there would be enough weakness from the layer orientation when printed flat in this case.
| Dell_WD22TB4_Holder_v1.stl | 326.8KB |
