I had noticed that the two remixed parts both offered something beneficial that I was looking for, but also both had a weakness I had to address. The first one (https://www.thingiverse.com/thing:4714245/remixes) fit on the deeper tables but had the original weak tabs that helped the april. The second one (https://www.thingiverse.com/thing:5173560) had a more secure method of holding the tape roll, but only fit on standard tables. I combined both of these to get the best of both worlds.
After printing, I realized that the tape dispenser does not hold a full roll of scotch tape, so I had to load in a partially used tape roll for it to fit. I will upload an updated model when I fix this. Extra padding was also added to ensure a good grip on the table.
| Clamp_Screw.stl | 1.9MB | |
| TapeDispenserCap.stl | 24.1KB | |
| Tape_Dispenser_Clamp_V3.stl | 285.5KB |
