Deep Space 9 Card Kit 3D Printer Model
The file 'Deep Space 9 Card Kit 3D Printer Model' is (stl) file type, size is 217.3KB.
The file 'Deep Space 9 Card Kit 3D Printer Model' is (stl) file type, size is 217.3KB.
A card kit of Deep Space 9.
Kit holds together with tension and a little glue
If you decide to print as separate pieces, please print 6 struts, 3 deflectors, and 3 pylons.
Would love to see your makes!
Instructions:
We want to start with the power ring, pictured in Step 1. While it's not adding much tension to keep anything together, this is the most likely part to need glue to hold together.
Once built, insert the long taper of the core into the slot of the power ring with the pylons facing up towards the ring mount.
Slide the main habitat ring onto the other end, over the command module of the core. There is a plain disc that will lock into the lower notch of the main core, keeping the core and habitat ring assembled.
Add the antenna array ring to the notch above that.
Add the docking pylon and shield emitter arrays to the spots in Step 5.
The pictures do not quite line up to the current assembly, which I will correct when time allows
| DS9_antenna.stl | 11.0KB | |
| DS9_card_kit_A.stl | 505.5KB | |
| DS9_deflector.stl | 8.1KB | |
| DS9_docking_pylon.stl | 26.4KB | |
| DS9_main_core.stl | 16.9KB | |
| DS9_main_core_lock_disc.stl | 9.7KB | |
| DS9_main_hub.stl | 146.4KB | |
| DS9_powerplant_core.stl | 11.4KB | |
| DS9_powerplant_strut.stl | 1.4KB |
